DD26 Hydraulic Steering Lock Clips Gen 2
The DD26 new patent pending design allows fitment for hydraulic steering systems with 3.75″ and/or 4″ of exposed steering rod on each side of the engine and will allow fitment with steering rods with diameters of 16mm, 3/4″, 20mm and 7/8″.
The way this system works is that the standard steering locks you purchased will come with the 3/4″ clips attached already. Those clips result in a 4″ width. Should you have a hydraulic steering system that has a different width or diameter, you simply can purchase the proper clips for your set up and switch them out at your convenience. Additional clips come in the following set ups:
- 16mm diameter providing total unit width of 3.75″
- 20mm diameter providing total unit width of 3.75″
- 7/8″ diameter providing total unit width of 4″
Each of these kits comes with 4 steering lock clips.
Fitment of a hydraulic steering lock has NOTHING to do with the ENGINE itself. So if you have a Mercury Engine it has nothing to do with the steering system. Its all about which hydraulic steering system you have.
A good guide of common fitment is: (but recommended to measure first)
- Seastar steering systems – Usually 4″ steering locks 3/4″ Diameter (most common) (These clips come standard with the DD26 Gen 2 Mean Stops)
- Seastar extra heavy tournament – Usually 4″ steering locks with 7/8″ diameter
- Baystar steering systems – Usually 3.75″ steering locks with 16mm Diameter
- Mercury steering systems – Usually 3.75″ steering locks with 20mm Diameter
- Uflex steering systems – Usually 3.75″ steering locks with 20mm Diameter Measure first
These second generation clips do not fit first generation mean stops!
Be the first to review “DD26 Hydraulic Steering Lock Clips Gen 2”
Related products
Sale!
MINN KOTA
$121.85
Sale!
Sale!
MINN KOTA
$49.99
Sale!
$12.00
Sale!
Sale!
HUMMINBIRD
$65.98
Sale!
Power-Pole
$122.56
Sale!
HUMMINBIRD
$166.00
Reviews
There are no reviews yet.